Abstract:
Electrical energy is proving to be a more and more important need in the
modern society. A spectrum of the electrical devices has spread and today the
trend is still toward smaller devices, which are more sensitive to the
disturbances over the electrical network and disrupted power supply. The
issue of surge protection in low voltage systems is of increasing importance
due to the vulnerability of modern electrical devices in a transient
environment. It is essential to investigate response of surge protection
devices to fast transients and its performance under repetitive current impulse
environment for an effective design of a protection system. Study of lightning
generated HF radiations is another key issue for proper insulation
coordination at the distribution level in accordance with the need &
sensitivity of the protected equipments in modern world.
Investigating the HFs radiated by lightning, it was found that about 87% of
negative ground flashes, HF radiations at 3 MHz, 5 MHz, and 10 MHz are
stronger at the onset of the return stroke. For 13% of flashes it was strongest
radiation at the leader phase. It was observed that the leader like pulses
appeared at leader phase and after the return stroke act as a strong source for
HF radiations. Out of the 526 pulses analyzed, 298 were found to be due to
positive field change pulses and 228 due to negative field change pulses. The
average rise time of those pulses was 0.127 ps and the peak amplitude was in
the range of 0.65-2.19 V/m.
The studies to investigate the behavior of surge protective components
revealed that, clamping voltages of tested surge protective components due to
fast transients were considerably greater than that measured with the standard
8/20 ps current impulses. It was found that the varistor models need to be
improved in order to have a better agreement for fast transient environment.
It was observed that if the varistors do not fail physically or if there is no
relaxation time period in between, maximum clamping voltage will not
increase further but it will asymptotically approach to a certain value
depending on the individual characteristics of the varistor under a repetitive
current impulse environment. Further more, most of the physical damages
(90%) were observed at the surface coating of the varistors. Surface
flashovers could be the main reason for this type of damages. Dielectric
behaviour of the varistor surface coating & the electrode contact system, and
manufacturing defects of the varistor surface coating could be a major
influence on withstand capability under the repetitive impulses. It was
observed that the surface flashovers may occur and varistors may be
physically damaged before reaching the clamping voltage failure mode